Mill/turn machining center

Published November 29, 2018

The M120 Millturn machining center handles lengths ranging from 78" to 315" and swings up 48". Offering power ranges up to 168hp and torque values up to 8,680 lb-ft in the main spindle, high feed rates on all axes deliver consistent productivity. The 74hp direct-drive milling spindle offers maximum power, even at low speed rates, advantageous when using large drills and milling cutters.

Clamping forces of the B-axis allow the use of damped boring bars with a diameter-length ratio of up to 1:14. A separate magazine is available for heavy ID-machining tools up to 5ft and 320 lb.

Turning, boring, milling, gear cutting, deep-hole boring, and ID-machining are possible in any angle

WFL Millturn Technologies
http://www.wfl.at

Read Next

Motion control for a heavy-duty test stand

November December 2018
Explore the November December 2018 Issue

Check out more from this issue and find your next story to read.

Latest from Aerospace Manufacturing and Design

More from Aerospace Manufacturing and Design

Vertical Aerospace brings Valo to New York

Industrial display for enhanced HMI, visualization

Eve Air Mobility secures $150 million financing

Tooling optimized for aluminum, titanium, and nickel alloys

Additive Manufacturing: Analysis. Trends. Forecasts. webinar with Terry Wohlers

Ethiopian Airlines orders nine Boeing 787 Dreamliners